Jump to content

Power Commander Maps

Fueling Maps for use with Powercomander Moduals

47 files

  1. Dyno custom map for torque

    This map came loaded in my new to me 2003 VFR800. The guy who had the bike before the girl I bought the bike from had it dyno'd to his specs with a LeoVince and K&N air filter setup. This is pretty torqued for me (I am also new to sport/touring bikes). I loaded in the generic LeoVince map from the power commander site and that one is a little gentler to me, but I wanted to contribute something to the community. Let me know if you like it. I don't think this map is used for gas mileage.

    109 downloads

    2 comments

    Submitted

  2. 16-005-508/018 blend

    This is my first post, but I have been reading the forum for years. I just got a PCV during the pandemic to kill some time and ran into a dead end in terms of maps for my bike:
    1999 VFR800 with Vance & Hines SSR slip-on, airbox top lid removed (no flapper, snorkel, etc) with pipercross high flow filter in place. Before installing the PCV it was sounding and feeling like a 250 parallel twin until I fattened up the "1998-1999 Erion slip-on" map from Dynojet, by adding the difference in fueling points between the 16-005-503 vs 16-005-508 maps between 2% - 20% WOT until 6000 RPM to accommodate the "airbox valve disabled" as its listed in the Dynojet notes. Although, Dynojet support advised against using the European maps at first, I was able to make it work by subtracting -6 points (~2 jet sizes) from the fueling numbers on 16-005-508 across the table from 2-20% and from 750 - 6000 RPM (assuming my ECU is enabling the 2nd intake track at 5500 rpm and disabling it at 5000 rpm, per the service manual) I test drove it today and it does make a big difference. Again this map is a hybrid mix of the Euro '02 airbox valve disabled map and the '98 erion slip-on map 16-005-018. I have tried out all the other maps listed here on this forum and this one works best for my bike. Cheers!

    27 downloads

    0 comments

    Submitted

  3. PCV 2002-2005 catless map. 46-48mpg highway

    This map is for the 2002-2005 VFR800. mods are K&N filter snorkel mod, 1999 catless headers, stock mufflers completely gutted, and the 02 delete or optimizers. Runs very smooth and gets around 48mpg on the highway. I'm going to be checking the WOT fueling when my wideband gets here. The current 100% fuel setting is from a dyno tuner in wisconsin but I want to check it for myself. I also have the acc pump activated sensitivity 65.9  30 revs and 15% fuel.. Took it to the 1/8 mile strip with this and ran a 7.40 at 101 and that was my first time running it at the track. I will update the WOT fueling after I get the wideband. 

    101 downloads

    2 comments

    Submitted

  4. 2002 vfr800 dyno tune map for power commander V

    This is a map that was set up on a dyno in Wisconsin. I leaned it out a little in the cruise area. It's set up for a catless header with the flapper air box mod and K&N air filter and using the O2 optimizers. I got this from the tuner I bought my power commander 5 from. Seems to run very smooth and pulls hard.

    121 downloads

    0 comments

    Submitted

  5. Cozye's Map Modified for an 06+ VTEC

    I just modded Cozye's PC3 map and ran it on my '06, pretty impressive power gains with gas milage savings at highway speeds to boot. VTEC is pretty smooth too. I'm going to run it for a while to see how it does. If anyone else decides to run it let me know how it does for you.

    653 downloads

    9 comments

    Updated

  6. PC111 usb 2002-2005 Vtec Australian / Euro. Modded Cozye map

    Map for 2002 Vtec Aust / Euro with Staintunes, o2 elim, K&N filter, Cat converter drilled (gutted)
    Based on Cozye's map for PC111 usb, but tweaked for AU. on Dyno.

    130 downloads

    2 comments

    Updated

  7. pc3 usb map

    mods:
    motad headers
    2 bros exhaust
    bmc filter
    no flapper or snorkel, pair valves
    modified velocity stacks

    77 downloads

    4 comments

    Submitted

  8. 05 PCV individual cylinder Dyno Tune

    Hey guys,

    after installing my new complete exhaust system i set the big girl off for a tune.
    asked for the guy to tune each cylinder individually.

    came back with this..

    runs really nice. only thing i might change would be first thing in the morning some times the big will stall when you come off the throttle.

    let me know if someone knows how to fix this.

    thanks. hope someone enjoys this..

    108 downloads

    1 comment

    Updated

  9. 2002-2005 PC3 Map: w/ Catless Headers, Staintunes, & K&N Filter

    This map was Dynotuned on a 2004 w/ 5th Gen Catless Headers, Staintune Slipon Exhaust, 02 Sensor Eliminators, K&N Air Filter, & PC3.
    !!! MAP NOT TO BE USED W/ STOCK HEADERS !!! CATLESS HEADERS ONLY !!!

    260 downloads

    3 comments

    Updated

  10. 5th Gen PCII & PCIII maps

    Some of these I pulled from the Power Commander site. For the files that are corrupt on that site I searched the net and found the missing files on some old plain .html personal blogs such as:
    http://homepage.ntlworld.com/stu.tyrrell/PowerCommanderMaps.htm
    Note that some of the PCII files have modified ignition. 
    Make sure and critically analyze any map before implementing it! I have nothing to do with these maps except that I searched for them and posted them here.
    - Knight
     

    122 downloads

    0 comments

    Updated

  11. Old Power Commander 2/3 Stuff

    This is a recovery of an old PCII directory from long ago when I had one on my VFR. I believe there is software in it to edit both the PCII and PCIII maps. I no longer have either of those to test it out, but the programs open map files and such. The biggest pain was finding a USB->COM port adapter for the laptop, alternatively I remember being able to remove the PCII from the bike and hook it up to a desktop with a com port with a 9V battery to power the PCII.
    I didn't check, but I _think_ all the old PCII maps (excluding California) uploaded by Miguel are in this zip file.
    Just putting this out there because someone was looking for it.

    124 downloads

    1 comment

    Submitted

  12. OFFICIAL COZY MAP - (cozye_ver5.djm) - Famous vtec pc3 USB map.

    Thanks a million to HS for setting up this downloads section. Well, here is my map for everyone to download. This is the same map that is featured in Motorcyclist Magazine (May,07 pg 159).
    This map should work perfectly on any 2002-2005 VFR with aftermarket slip on and o2 eliminators. It will work well on any vtec really, regardless of exhaust. If running stock exhaust you may want to go in and lean it up just a touch. Try it first though and see before tweaking. If anyone feels like they can make some improvements, go for it. Many minds are greater than one.
    I believe Tinyminds has dyno'd this map and got around 101 hp or so.
    This map wont work well on 2006-2007 models with the lower vtec engagement. You could probably take the map and modify it accordingly for the lower vtec range. If someone attempts this, please post it up for other newer vtec guys to use. I've had quite a few 06-07 owners ask for it. My thoughts are that you could copy mine below 6000, and above 8000. Then just mimick what I did with the fuel curve on the dynojet supplied version from 6000-8000. Just smooth out the fuel curve.
    enough rambling.
    One request however. If you use the map, and you really like it. Why not make a small donation to VFRD ? I would guess there are probably 150 people who have or are using this map (just going by the fact that I have had about 300 request for it). If all those people chipped in 5 bucks, it would be quite a bit of dough to go for our wonderful community. Just a thought. :thumbsup:

    1241 downloads

    6 comments

    Updated

  13. PC5 on a 5th gen VFR

    Hi all, here's a map for the PC5 on a 5th gen VFR. As you can see from the pic, the air box has been hacked up pretty good. Using a PiperCross filter, Staintune hi mount, Pair's disabled and o2 sensors disabled. Runs like a batt out of Hell.
    Enjoy.

    87 downloads

    1 comment

    Updated

  14. black06vfr's map

    Here it is. A power commander map for a BMC race filter, O2 elims, and Migs exhaust.

    149 downloads

    2 comments

    Updated

  15. 2000-2001 VFR Power Commander Maps

    all availible maps from Dynojet for the PCIII version y2k 5th gen with closed loop injection (o2 sensors) this is a self exstracting zip file

    172 downloads

    2 comments

    Updated

  16. 2002 - 2005 Honda VFR 800 VTec Downloads

    all dydnojet maps availible for the PCIII VTEC

    326 downloads

    0 comments

    Updated

  17. Cozye's Map PCIII NON-USB

    Here is a version of Cozye's map converted to run on a nonUSB PCIII.
    Because Cozye's map has adjustments for every 250 RPM, and nonUSB PCIII only has ever 500 RPM, I made a few minor tweaks, usually only 1 % richer to try to get the same AFR between 500 RPM marks, but for the most part, it's just the same numbers copy-pasted over into the different format.
    This is for the 2002-2005 models.

    138 downloads

    0 comments

    Updated

  18. 1998-1999 VFR Power Commander Maps

    All availible PCII maps from Dynojet for the 5th generation open loop fuel injection system NO O2 sensors

    275 downloads

    2 comments

    Updated

  19. 1998-1999 VFR Power Commander Maps California

    All availible pcII maps from Dynojet for the California Model 5th gen bike open loop fuel injection system NO O2 sensors

    73 downloads

    0 comments

    Updated

  20. 2006 - 2007 Honda VFR 800 VTec Downloads

    All availible maps from Dynojet for the VTEC using the PCIII-USB

    270 downloads

    0 comments

    Updated

  21. 2006 Euro PC111 map

    This is a custom map for a 2006 Euro (Australian delivery) VFR800 with the following mods:
    98 ceramic coated headers
    Leo Vince Evo11 carbon mufflers with baffles in
    O2 sensors eliminated
    Flapper deactivated
    Snorkel removed
    Air funnels (velocity stacks) changed to 4 long from standard 2 short 2 long.

    66 downloads

    0 comments

    Updated

  22. VTEC 2002, EU version

    BMC Air filter
    TwoBros exhaust
    O2 elims
    If you have TWO BROS on EU model, you can try this map. There is no special map for EU model with TWOBROS shipped from PC and I had very bad transition at 7k rpm with all other EU maps and these exhausts.
    Supplied maps are too rich at 7k rpm and throttle opened at 40%-60%.
    mk

    77 downloads

    0 comments

    Updated

  23. Cozeys map PC3 non usb

    Cozeys map for non usb model power commander 3. Every other line taken out to work with rpm change every 500 rpms instead of every 250 rpms as with PC3 usb model. For some reason it would not let me use the .map file extension so I just picked another one that it would let me load. I think you can just change it manually from .mov to .map and it should work fine.

    63 downloads

    0 comments

    Updated

  24. 2006VFR800MotadScorpionK_N.DJM

    File Name: 2006VFR800MotadScorpionK_N.DJM
    Power Commander PCIII USB + “Accelerator Pump”
    2006 VFR800
    Scorpion Exhaust
    O2 Eliminators
    Motad Catless headers
    K&N Air Filter
    De-flapped,de-snorkled
    All PAIR equipment intact
    97HP Dyno’d in Las Vegas at ~2,000 above sea level, ambient air at 110 degrees F.
    As Cozye said, “If you use the map, and you really like it; why not make a small donation to VFRD ?”

    137 downloads

    1 comment

    Updated

  25. 2007 VTEC Euro-Australian version

    2007 VFR800 VTEC (Euro -Australian model)
    leo vince slip-on exhaust,standard air filter,Airbox Flapper deactivated, snorkel removed,Dynojet O2 eliminator kit, standard headers and CAT.
    Tuned by DM 22-02-09

    87 downloads

    0 comments

    Updated


×
×
  • Create New...

Important Information

By using this site, you agree to our Privacy Policy.