Auspanglish Posted September 28, 2015 Share Posted September 28, 2015 Was just flipping through the manual looking for front wheel bearing specs and discovered an error in the 6th gen workshop manual. In the secton on assembling the front forks, right after detailing the 100 mm gap from the top of the fork upper to the level the fork oil should come to (100 mm), It mentions to remove the cylindrical spacer (collar) and seat (washer). The error obviously lies in the use of the word "remove" instead of "install". It's quite obvious as it is right smack bang in the middle of the assembly instructions but if someone were to follow the manual blindly... Quote Link to comment Share on other sites More sharing options...
Member Contributer Mohawk Posted September 28, 2015 Member Contributer Share Posted September 28, 2015 If they were that blind, they should not be working on it ! But good spot. Quote Link to comment Share on other sites More sharing options...
Member Contributer Switchblade Posted September 28, 2015 Member Contributer Share Posted September 28, 2015 You have a lot more time then me but yeah good catch . Quote Link to comment Share on other sites More sharing options...
Auspanyol Posted September 28, 2015 Share Posted September 28, 2015 Yeah it's pretty damn obvious but hey... Everyone has to have their first time sometime. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.