Member Contributer Grum Posted August 22, 2022 Member Contributer Share Posted August 22, 2022 Good news well done. Was the HISS warning light giving you any indication the system wasn't right at switch on? I guess at the time when I asked "Do you hear the Fuel Pump Prime and the Fi light goes out after 3secs at every switch On" your problem was intermittent, because, if the HISS is faulty you will NOT get Fuel Pump Prime at switch ON. Link to comment Share on other sites More sharing options...
Member Contributer St. Stephen Posted August 22, 2022 Member Contributer Share Posted August 22, 2022 4 hours ago, Skids said: Well done all +1 Skids. Grum and Danno hard to beat. Seems like a situation Cogwell might address also. Haven't seen him here lately, hope he is OK. Link to comment Share on other sites More sharing options...
Member Contributer Grum Posted August 23, 2022 Member Contributer Share Posted August 23, 2022 2 hours ago, St. Stephen said: +1 Skids. Grum and Danno hard to beat. Seems like a situation Cogwell might address also. Haven't seen him here lately, hope he is OK. Had exactly the same thought about Cogswell he hasn't been on the forum for a long while, out of character, I do also hope he's ok. Hey Cogs, Are You Out There? Has anyone seen or heard from him? Link to comment Share on other sites More sharing options...
BSR67 Posted August 23, 2022 Author Share Posted August 23, 2022 13 hours ago, Grum said: Good news well done. Was the HISS warning light giving you any indication the system wasn't right at switch on? I guess at the time when I asked "Do you hear the Fuel Pump Prime and the Fi light goes out after 3secs at every switch On" your problem was intermittent, because, if the HISS is faulty you will NOT get Fuel Pump Prime at switch ON. Hi No, not that was obvious. That said, I wasn't looking for it to be HISS initially. The HISS light lit when the bike came back to life. I stripped the yellow/red out - it had literally broken with a 90 degree bend/kink. They are fine wires. Ended up doing a little solder surgery - I had stripped back areas of the four wires to undertake continuity checks. Ended up splitting all three remaining wires so I could heat strink the areas where I had stripped back the insulation. I then re-sleeved the whole lot to preserve/protect. The good news is, it is fixed now, and I am grateful to you, and others here, for the help and guidance. BSR67 Link to comment Share on other sites More sharing options...
BSR67 Posted August 23, 2022 Author Share Posted August 23, 2022 11 hours ago, St. Stephen said: +1 Skids. Grum and Danno hard to beat. Seems like a situation Cogwell might address also. Haven't seen him here lately, hope he is OK. 100% hard to beat! BSR67 Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.