Member Contributer wrestler Posted August 7, 2014 Member Contributer Share Posted August 7, 2014 Rollin Again and I went to his garage to solve a brake squealing issue. We dismounted the front brakes. They were almost like new. We dismounted the rear assembly. One side like new. other side completely worn. Anybody got a thought about what is going on here?? Link to comment Share on other sites More sharing options...
Member Contributer gmtech94 Posted August 7, 2014 Member Contributer Share Posted August 7, 2014 Depending on which side wore out it may be a sticking piston/seal or the sliding pins were coroded ,bent not allowing the outside pad to float along and release Link to comment Share on other sites More sharing options...
Member Contributer vfrcapn Posted August 8, 2014 Member Contributer Share Posted August 8, 2014 Please don't say brake "shoe"... Link to comment Share on other sites More sharing options...
TNRabbit Posted August 8, 2014 Share Posted August 8, 2014 I had the same problem; it was either sticking pistons or sticking slider pins--pistons appeared to be ok so.... Cleaned it all up & lubed...no more issues. Link to comment Share on other sites More sharing options...
Member Contributer wrestler Posted August 9, 2014 Author Member Contributer Share Posted August 9, 2014 Thanks for the help guys Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.