I am considering installing some custom frame sliders on my 02, and am just measuring up the location for the hole.
My concern is that the location on the fairing that I need to drill, does not leave any margin of connected plastic, once drilled.
THe dot in the centre of the yellow dot - is the centre of the hole. From there - the hole will be 3/4 inch in all directions. (The hole saw is 1 1/2" )
My fear is not in drillign the holes, its what the fairing will do after in terms of stress cracks because it has been compromised.
Radar in Saskatoon has sent me a kit to use to drill the holes, and he has made an aluminum base that will bolt to the engine bolt, and then the solid Delrin slider mounts to the aluminum.
ANyone that has a close up of the hole they drilled - or even a shot of where they mounted their sliders for a 6th gen - I'd appreciate seeing that.
Question
KanadianKen
I am considering installing some custom frame sliders on my 02, and am just measuring up the location for the hole.
My concern is that the location on the fairing that I need to drill, does not leave any margin of connected plastic, once drilled.
THe dot in the centre of the yellow dot - is the centre of the hole. From there - the hole will be 3/4 inch in all directions. (The hole saw is 1 1/2" )
My fear is not in drillign the holes, its what the fairing will do after in terms of stress cracks because it has been compromised.
Radar in Saskatoon has sent me a kit to use to drill the holes, and he has made an aluminum base that will bolt to the engine bolt, and then the solid Delrin slider mounts to the aluminum.
ANyone that has a close up of the hole they drilled - or even a shot of where they mounted their sliders for a 6th gen - I'd appreciate seeing that.
Feedback is needed......
thanks
Link to comment
Share on other sites
26 answers to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.