Whitepine

I have a 2003 non abs vfr 800, two brothers. Exhaust De snorkeled. I modified cozy's map and code righter's map to work on my pcV. I think you could start with That map and go from there. It's under the more tab/downloads.

I would like to see a dyno run with and without the hho

Wagner H4 bulb BP1210/H4 at NAPA.The bulb goes for around $12 nice and bright and less than halve the cost of the silverstars

I know that part of Goonies was filmed in Astoria, Or. But back on topic, I will have to put Mt St. Helens on my list.

Try the wagner H4 bulb BP1210/H4 at NAPA. The Old packaging says for Off road use only... but the new packages says it is original equipment replacement. the bulb goes for around $12. Cheers, Whitepine

Check out Darth Blings mirrors... not hondas but they work. http://www.vfrdiscussion.com/forum/index.p...c=43247&hl= http://www.vfrdiscussion.com/forum/index.p...&hl=mirrors

I just squeezed my horn up there where the old horn was.... I also used the old bracket to fit the Stebel into place. Pretty tight but it is out of the way and you cannot really see it. Thanks for the write up. Cheers, Whitepine

The map that I'm making with the Autotune is only going to work on '06-'09. As far as fuel mapping, the '02-'05 is very different from '06-'09. If you can find a PCIII map that matches your bike, I can convert it to a PCV map if you'd like. You can also get a Autotune or wait for someone else with a '02-'05 to get one, then you will have a true 6 gear PCV map. Sooner or later someone will autotune the '02-'05. Until then, you can always run a converted PCIII map. maybe I could start with Cozy's map and autotune that. Cheers, Whitepine

I have been thinking of adding a pcV to my 2003 vfr and was hoping you would post your map. Now I just need to get and install the pcV.

http://www.zgoutlet.com/ Cheers, Whitepine

I wonder if you could set this up on the bottom edge of the windshield. When it goes off, the top edge would flash your chosen color. That would be pretty cool.

I am looking to get someone in the Seattle area with a 6th gen vfr to let me make molds of their upper cowl and the right and left cowls so I can make carbon fiber ones. I am in the Seattle area and would only need the cowls for a few days to make the molds. We could probably work out a deal for carbon panels for yourself too. Pm if you are interested and we can work out the details. Cheers, Whitepine