Leaderboard

First run set install report. I made a small clearance cut in chin fairing and added heatshield including around right fairing boss just below that opening. The center stand just barely rubs in its upright position - works for me. I had it wedged on install but by the time it was all torqued it just touches. I bet I could clear it if I had another set of gaskets. Repacked the carbon pipe and used permatex copper on the two slip joints after expanding the mid pipe with an autozone tool and impact gun. Have the KN filter now and PC3 with the 302 map and will try the full erion map next. Thanks everyone for the work getting this together and the tips in this thread to get it installed. Sounds incredible and much better low end driveability and mid range torque!

Hello guys! I've found some time to introduce You to my track bike which is Honda VF500 F2 from 1985. Just a year older than me;) Because I build custom motorcycles I've swapped the frond and rear (whole) from Honda VTR 1000 Firestorm from 2000. Mod was made mainly because of poor tire choice for the track with original setup. Front was straight forward. Plug and play really with only clock's subframe re-weld for wider forks. Rear was ultra hard:) I've welded and machined almost everything in VTR swingarm. Plus I had to make new pro-link triangles for CBR sc59 shock. Take a look on those photos.

Re-installed the charging system and added some lights for some bike nights.

got em on. woah they're good

Captain, I'm drooling. The wheels, the case/coolant hose guards, the exhaust, clip-ons, and whatever you did to the clocks, just beautiful. What would you charge me to rent it for a month? 😎

VFRD header versus 6th Gen header.