Rob Posted April 16 Share Posted April 16 I have a 2007 VFR800, I just upgraded my rectifier and replaced the battery. I took it out on a test drive about 5 miles. As I was pulling into my drive way the bike died. When I turn the key on nothing happens, no lights on the instrument cluster no fuel pump priming. I'm looking for a starting point to start tracing the problem. I've checked the 30 amp fuse next to the battery it's ok. Battery has 13.1 volts. Any suggestions would be greatly appreciated. Quote Link to comment Share on other sites More sharing options...
jstehman Posted April 16 Share Posted April 16 Starter solenoid fuse and the red wire from that is where I'd check Then the connector for the ignition wiring Sent from my SM-S911U using Tapatalk Quote Link to comment Share on other sites More sharing options...
styran Posted April 24 Share Posted April 24 On 4/16/2024 at 11:15 AM, Rob said: I have a 2007 VFR800, I just upgraded my rectifier and replaced the battery. I took it out on a test drive about 5 miles. As I was pulling into my drive way the bike died. When I turn the key on nothing happens, no lights on the instrument cluster no fuel pump priming. I'm looking for a starting point to start tracing the problem. I've checked the 30 amp fuse next to the battery it's ok. Battery has 13.1 volts. Any suggestions would be greatly appreciated. Check both 30A main fuses one connected to starter solenoid and the other near battery. Then check grounds. Check battery-to-frame ground (under gas tank hinge) and frame-to-harness ground as well Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.