Jump to content
  • 0




1 answer to this question

Recommended Posts

  • 0
  • Member Contributer
7 hours ago, Padraig said:

Hi people just got my VFR 800 2002 back up and running with a good bit of work done on it but can’t get the ABS light off. New sensor put in. Any suggestions?

Not much detail in your fault description!

- Are your tire pressures correct?

- ABS is sensitive to battery status, is your battery and charging system good?

- Are you saying that the ABS light remains On once bike speed is above 6mph?

- Any physical damage to either of the Pulser Rings?

- Are all four ABS fuses good?

- Have you gone through the Service Manual for fault code checking?

- Could the "work done" have effected ABS wiring and connections?

- Was the issue there prior to work done?

- What new sensor? Front or Rear? Did it have a fault code for the sensor?

- Are the Sensor to Pulser Ring air gaps correct?

- Have you checked all the ABS connections and connectors are clean and making good contact?

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Answer this question...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Create New...

Important Information

By using this site, you agree to our Privacy Policy.