I have a 2008 VFR800 ABS that I put Galfer stainless steel lines on. Following the bleeding procedure in the Honda service manual I was unable to bleed them trailered it to a shop. They bled them and the pedal feels nice and tight. However yesterday I was going for a ride, went down my street towards the stop sign and found that there's no modulation in the pedal and it's just nothing of full dead stop. The lines are correctly installed.
The shop is owned by a family friend and they are picking the bike up some time this week to sort it out.
In the mean time, I've been researching trying to figure it out. I haven't found anything like I'm experiencing.
I thought I'd come here, get opinions and see if anyone else has had this issue. Thanks.
Question
bryandvfr
Hello,
I have a 2008 VFR800 ABS that I put Galfer stainless steel lines on. Following the bleeding procedure in the Honda service manual I was unable to bleed them trailered it to a shop. They bled them and the pedal feels nice and tight. However yesterday I was going for a ride, went down my street towards the stop sign and found that there's no modulation in the pedal and it's just nothing of full dead stop. The lines are correctly installed.
The shop is owned by a family friend and they are picking the bike up some time this week to sort it out.
In the mean time, I've been researching trying to figure it out. I haven't found anything like I'm experiencing.
I thought I'd come here, get opinions and see if anyone else has had this issue. Thanks.
Link to comment
Share on other sites
1 answer to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.