Member Contributer kaldek Posted April 24, 2012 Member Contributer Share Posted April 24, 2012 If you're considering a Screaming Banshee, this video will show you how and where to install it. Note that it's specific to the non-ABS model bike and a different location would be required if your bike has ABS. Another member mounted theirs to the stock horn location, but anywhere under the fairing will work. Your only limits will be cable lengths but you can always increase those as needed. Quote Link to comment Share on other sites More sharing options...
Member Contributer HighSideNZ Posted January 13, 2013 Member Contributer Share Posted January 13, 2013 (edited) With the wiring that is needed to be completed for the Screaming Banshee! I've just fitted one, and put it in the exact same place as shown in the video, but there is no need to fit the 2 blue wires for the horn directly to the existing horn itself. When you have the left fairing off, the cable that comes from the left handlebar switch block has 2 plugs on the end of it. A clear coloured one, which has the dark blue cable for high beam, and a red plug and this has 2 wires in it that are the horn wires. Tap in to these directly for your connection to the horn and you are all good to go. The only wire I had to install at any distance from the Banshee controller was the red wire going to the battery + Makes for a very neat install. Also, when tapping in to the wires from the switch block make sure that you tap into the wire on the loom side of the plug and socket not the switch block side. This way, if you have to replace the switch block, you do not need to re-do the tapping. (Very unlikely that you will need to replace the loom, but a damaged switch block after an accident is more likely) Cheers Phil Edited January 13, 2013 by highsidenz Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.