Jump to content


  • Posts

  • Joined

  • Last visited

Profile Information

  • Location
  • In My Garage:
    Vfr 750 f from 1986

Rctwentyfourseven's Achievements


Newbie (1/14)

  • Week One Done
  • First Post
  • Conversation Starter

Recent Badges



  1. Thank you for the replies. Nice to know. I think it must have gotten a beating lying in between the sprocket and the sprocket cover or something. I will try and get a replacement washer and use this bolt until i get a new original bolt and washer. Does anyone know the diameter of the washer?
  2. I recently changed the chain and sprockets on my bike. After a while, the drive sprocket bolt fell out. It seems too short, and a bit cut, and with some debris in the hole where the nut was, I am assuming it broke off inside and then screwed itself out. Now I am worried if the rest of the bolt is inside. I did some measurements of the depth of the hole and the length of the screw. Can anyone tell me how deep the hole should be and how long the bolt originally is? The hole is 29mm deep The entire bolt is 30mm long and has 9 rounds of thread. Also, what is the diameter of the washer? The original has disappeared, but if the bolt still works i could get a replecement if i just have the specs.
  • Create New...

Important Information

By using this site, you agree to our Privacy Policy.