-
Posts
4 -
Joined
-
Last visited
Content Type
Forums
Profiles
Gallery
Blogs
Downloads
Events
Posts posted by MEZZANlNE
-
-
I’ve been asked a few times to share this tail tidy, its a bit easier to install and less permanent than some of the other designs I’ve seen
I printed it in black petg, 20% infill. It replaces the factory rear reflector. If you live in a country that requires a rear reflector I have another file for a bracket to mount an aliexpress reflector below the plate. Requires:
- 2 holes to be drilled for licence plate bolts, these could be added in with your slicing software but it was easier for me to drill them
- 2x 20mm M6 bolts to fix the plate (3/4” x 1/4”)
- 1x 25mm M6 bolt to fix the tail tidy (1” x 1/4”)
- 3x M6 nylock nuts (1/4”)
- 6x M6 washers
- 3
8th Gen RC79 Tail Tidy STL for 3D Printing
in Eighth Generation VFR's
Posted
Nah. I have a delkevic short without the db killer, I find it sounds cool and I can hear it with earplugs, but its gets a bit quiet in heavy traffic once the bike is hot
I tried just the midpipe both to see if it would be much louder but also to show off the rear wheel better, and if I liked it I was planning on getting a pipe made with a better angle. It sounded a bit tractorish so I didn’t bother. Coffman might be the answer but its overpriced