Well I found this thread helpful, especially the pictures, so I thought I'd add a few of my own that might help others doing this swap.
I dug through my bin of "crap-I-thought-might-come-in-handy-someday" and found some aluminum bar, pre-drilled and with a set screw. I think it may have been part of a bicycle wind trainer but not sure. Whatever it is, it fit the bill perfectly. :laugh:
I cut down the spacer and ended up at 66mm eye to end. This should give a tad bit more ride height as Jamie suggested. On the left you can see how much of the old bolt had to be ground away before it could be tapped out.
Mounted on shock........
And how it sits on the 4th gen frame.....
-18 F here this morning so no test rides....have to wait till spring :blush:
Anybody have any feedback on compression/rebound settings? (I'm about 225lbs without gear)