I sent a stator to Custom Rewind and had them upgrade the windings as well as put a Yamaha connector on the output leads. Got it back and installed it in a buddy's 98 with about 20k miles on it. We previously installed an R1 R/R but this was on our list to complete. Even with the R1 R/R, his volts never rose above 13.6v. It appears we completed the upgrade in time..... Custom Rewind continues to do excellent work, 14.4v at idle.
I have air, fuel, and spark at each plug. Sidestand/neutral/bank angel sensors are functional. The engine seems to turn over a bit slower than I'm used to. Battery is fully charged. I believe the engine was assembled correctly and have no reason to believe differently. Next step is to check the pulse generator.
HRT engine is in and all plumbing/electrical are connected. Having a bit of trouble firing as I only get a puff or two while cranking. I've checked all my connections and I'm sure fuel is present. I'll start the drill and work on the spark side of the triangle. Input is welcome.
Jim
Step 1 of the swap. Original engine in the storage cradle. Salvaged frame with legs. I hope to spoon the HRT engine in tomorrow. Injectors returned and are ready for install. All 8 are now back to factory speck.
Waiting on SS silicone clamps (arrival tomorrow), new thermostat and a few more small bits. Hope to fire it up sometime next week.
Injector RX received my injectors today, and they already completed the cleaning/refurb. They ship back tomorrow. Now, I sent the 8, hoping to get a good set of 4. Well, all 8 are now back to factory spec. Anybody in need of 4 factory new injectors?
Best pics I could achieve of the water pump. Not sure how much was done to the fins, but he cleaned up the inside of the cover.
Craig is a super easy person to deal with. He is a very honest chap even when presented with an open checkbook.
Cooling system is removed. Next will be the header, swingarm pivot bolt, and remaining frame mounts.