Jump to content

Leaderboard

Popular Content

Showing content with the highest reputation on 02/13/2019 in all areas

  1. Update - there’s not a lot to update. Wednesday I dropped off Prototype #1 at the metal finsher’s to be passivated (acid dipped). They’ll do this first set of headers for $110, and batches of 5 headers for $95 each. I’ll post photos of the treated headers later this week. Production headers are underway, but Wade was sick last week and bowed out of our Tuesday meeting. He’s feeling better (racing motocross sidecars in CA this weekend!) and I’m heading to his shop tomorrow. Objectives for this meeting are: (1) refine our approach to collector exit matching OEM angle/position - relates to having had only TBR and OEM 6th gen headers on hand when making the jig for the prototype. The cat on the 6th gen headers didn’t allow an accurate measurement of the OEM exit angle/position, so I’m taking 98/99 headers to Wade to confirm production units match OEM angle/position (98/99 tubing and merges allow measurement & duplication). (2) examine clearance required between the collector exit pipe and the bottom curve of cylinder #1 primary as relates to the header fitting over the diameter of the right side center stand leg during installation. Clearance at this point on Prototype #2 is enough to just squeeze over the right center stand leg, so the center stand doesn’t have to be removed to install or remove the headers. Clearance at this point on Prototype #1 isn’t enough to allow the header to pass around the center stand during installation - we had to remove the center stand, thread it through the headers, then mount the center stand with the headers dangling down at the base of the stand like pants around one’s ankles, then mount the headers. file
    1 point
  2. Its not that the bike needs more power, it is that I need to tinker.
    1 point
×
×
  • Create New...

Important Information

By using this site, you agree to our Privacy Policy.