Subframe mount & plugs
I cut off and ground flat one stud and drilled another hole to mount the RC51 regulator. A weld bead at the upper left was ground flush so the regulator could fit flat against the subframe. The junkyard-scavenged plugs that match the RC51 regulator harness are seen here as well. Visible at the far right is the slice in the harness tape made where I spliced in the voltage sensor circuit.
Copyright
© ©vfdiscussion.com
Recommended Comments
There are no comments to display.
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.