LoneStar66 Posted July 9, 2021 Share Posted July 9, 2021 Hi all. Am new to this forum and have a question about my 2002 vfr. While getting the bike ready for maintenance I had to remove the right side peg and heat shield. After removing it and cleaning things up I found I rather like it without the shield. Would this be an issue down the road for potential heat damage to plastics and rubber around the foot brake? Thanks in advance. Here is a pic of my new to me 2002 vfr. pwrcell_consumer_brochure_v12_digital.pdfpwrcell_consumer_brochure_v12_digital.pdf Link to comment Share on other sites More sharing options...
Member Contributer VFR78 Posted July 9, 2021 Member Contributer Share Posted July 9, 2021 Nice tractor😂 Link to comment Share on other sites More sharing options...
squirrelman Posted July 9, 2021 Share Posted July 9, 2021 without the shield the rear brake fluid could get too hot to work. Link to comment Share on other sites More sharing options...
Member Contributer gig Posted July 9, 2021 Member Contributer Share Posted July 9, 2021 tou have to take off and wrap the the rear down pipes, crate with heat paint to avoid possible rusting, wrap with 2' titainuim (only" heat wrap, mine runs cooler than with the heat shield. Link to comment Share on other sites More sharing options...
LoneStar66 Posted July 13, 2021 Author Share Posted July 13, 2021 Sounds good. Will take that advice..thanks for the reply. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.