Jump to content
  • 0

CBR 929 Triple into 97 VFR 750


TheCommando

Question

Hi all, working on a project trying to swap a CBR929 triple into a 97 VFR. Got all balls tapered rollers to replace the old worn out bearings. It seems as though the 929 stem is too short though. I cant get the second locking nut on under the top triple. Any advice?

 

Sent from my SM-G970W using Tapatalk

 

 

Link to comment
Share on other sites

2 answers to this question

Recommended Posts

I also have a 4th gen and CBR 929 triple setup, i can say that the bottom bearing that come original was ball type and the bars would vibrate over 100 km\h.

Then i change the upper and bottom steering bearings for OEM CBR929 tapered rollers type, straight swap and the problem was solved.

Link to comment
Share on other sites

  • Member Contributer

First I assume you have both lower triple T’s, if yes then measure the stems see how they compare length wise.


Make sure the internal bearing cups are fully seated home. Then if the second locking ring won’t fit, it should be fine if the top triple is snugged down on it. If not then use a locking tab washer, many bikes only have one top stem tension ring with a locking washer. 

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...

Important Information

By using this site, you agree to our Privacy Policy.