DonR Posted January 29, 2019 Share Posted January 29, 2019 Hi guys,Those of you that have had your liners re-bored, did you remove them for machining or had them machined still installed in the block? If you had the choice, which is the better/more accurate method?Regards,Don Link to comment Share on other sites More sharing options...
Member Contributer HighSideNZ Posted January 29, 2019 Member Contributer Share Posted January 29, 2019 As far as I am aware, the liners cannot be removed. You bore them in-situ. Link to comment Share on other sites More sharing options...
Member Contributer Mohawk Posted January 29, 2019 Member Contributer Share Posted January 29, 2019 I know for a fact that the VF1000R uses removable wet liners, but not sure about the F model though. They are flanged, no idea if they can be removed from the case without stripping the engine though. Link to comment Share on other sites More sharing options...
Member Contributer Dutchy Posted January 29, 2019 Member Contributer Share Posted January 29, 2019 @TheDutchy Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.