Jump to content

Pin size for triple tree stand?


jstehman

Recommended Posts

  • 1 month later...
  • Member Contributer

I have Pit-Bull's hybrid dual-lift:

 

https://www.pit-bull.com/hybrid-dual-lift-motorcycle-front-stand-f0100-200

 

It uses their standard pin with their #1 adapter:

 

https://www.pit-bull.com/front-stand-pins/adapter-1-front-f0001-051

 

When I put a caliper on that adapter, it looks like the outer diameter is just under 23mm. There is also a spring-loaded retaining button that might protrude slightly and add to the effective diameter.

 

I'm curious to the degree that discussions about fitments like these move between "true" measurements and "for use with" industry standards approximations. For instance, maybe a pin described as "24 mm" means "for use with standard 24mm receiver" rather than  OD = 24.0 millimeters.

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...

Important Information

By using this site, you agree to our Privacy Policy.