9C1 Posted December 31, 2017 Share Posted December 31, 2017 With the rear plastic off and looking at the bike from the left side, the big wire that runs behind the rectifier has another wire taped to it. About 6 inches past the rectifier this wire terminates and it has a double plug on it. Sure looks like something should plug into it. Anyone know what it's for? Link to comment Share on other sites More sharing options...
Member Contributer Terry Posted December 31, 2017 Member Contributer Share Posted December 31, 2017 Most likely you are looking at the Service Check Connector. That is where you plug in a jumper cable to read or clear fault codes in the FI system. Link to comment Share on other sites More sharing options...
Member Contributer JZH Posted January 1, 2018 Member Contributer Share Posted January 1, 2018 I think it's also used to re-program HISS keys (outside the USA, on HISS-equipped models, that is). Ciao, Link to comment Share on other sites More sharing options...
Member Contributer Ghostrider1127 Posted January 1, 2018 Member Contributer Share Posted January 1, 2018 Keys are programmed wiring a plug to pick-up connector service check connectors are red and with 4 pins May a picture will help..... Link to comment Share on other sites More sharing options...
Member Contributer JZH Posted January 2, 2018 Member Contributer Share Posted January 2, 2018 I'm sure it would! I've reprogrammed HISS keys before, using Kaldek's (formerly of this parish) helpful Youtube video (added below), but I don't remember which connector I used... Ciao, Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.