Forum CEO HispanicSlammer Posted July 23, 2002 Forum CEO Share Posted July 23, 2002 Installing Signal Cancel http://www.kisantech.com sales@kisantech.com November 5, 2001 The signal minder is a unit that replaces the Mitsuba turn signal relay on your VFR The unit can also be set so that if the brakes are engaged (at at traffic light) the signal minder will not cancel The unit cost $89 us at regular price VFR Forum Members 10% off regular price The unit automatically turns itself off, it can be programmed to shut off in 10 seconds to a minute. If they get enough orders the discount could go to 20% off 1-2 hour install time Standard tools from the kit Installation steps 1998-01 VFR Click here to view steps better Begin by removing the upper front faring Remove the side bolts 3 on each side 1 Remove the dash bolts 2 on each side 2 Remove inside moulding one screw on each piece 3 Remove the inside dash screws one on each side 4 Remove the mirrors two10mm bolts 5 Take note of plate and rubber seal placement 6 Remove outer screws 7 Watch out the windshield snaggs, there are several plastic fasteners on the faring that need to be removed I damaged one of them, be carful when removing them (rod and splay type plastic fasteners) 8 Carefully pull off faring, the headlight wires are attached, it is not nessary to remove it entirely just move it so you have room to remove the Misuba relay 9 I just moved it out of the way enough to reach in and remove the old relay 10 Here is the OEM relay hanging from a rubber mount 11 Carfully remove it, it has a locking connector, it is hung from a rubber mount with a palstic hanger 12 The Signal minders plugs right into the same harness, it comes with a velcro fastener 13 I opted to go one further and zip tie it in as well 14 I zipped tied it horizantal and vertical 15 Close up view 16 This part is optional if you want ot connect the brake input, remove the seat and tank (need to rout a wire from brake light to front faring) 17 I tapped into the rear brake light using an inline tap as shown (Radio Shack $1.29 @ 4 clips) 18 Tap into one of the rear brake lights, the left side wire that is( green with a yellow stripe and red dots) this provides 12 volts input to keep the signal minder from canceling while the brake is engaged 19 Run a wire from the rear brake light to the front faring and connect to the bottom of the Signal Minder Follow the same steps backwards to put it back together, I found it was easier to put back together. :cool: Quote Link to comment Share on other sites More sharing options...
Guest Montrealer Posted October 2, 2002 Share Posted October 2, 2002 Can this be done on the 2002 VFR? Quote Link to comment Share on other sites More sharing options...
Forum CEO HispanicSlammer Posted October 2, 2002 Author Forum CEO Share Posted October 2, 2002 Yes, It is just a swap out of the turnsignal relays. The relay is located behind the top cowling behind the dash. It is just a simple plug and play device. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.