Member Contributer TheLimey Posted September 28, 2022 Member Contributer Share Posted September 28, 2022 I recently tried to install a knock-off KOSO RX-2N speedo on my 6th Gen and, lo and behold, it's rubbish. No combination of button pressing will allow me to calibrate either the tacho or speedometer on it. Anywho, I'd like to go back to the original unit but have apparently lost my very carefully written notes detailing the original 20P connector pinout. I know from my Haynes manual which wire goes in which pin, but I'm unsure in which order. Is it 1 to 10 across the top row, or is it N-pattern where position 2 sits directly beneath position 1 on the bottom row? Could somebody please take a picture of the back of their speedo connector so I can piece together the correct pinout? Link to comment Share on other sites More sharing options...
Member Contributer TheLimey Posted October 3, 2022 Author Member Contributer Share Posted October 3, 2022 Anybody able to help me out with this? Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.