Jump to content

Hello from London - VF1000R


ROOTS

Recommended Posts

  • Member Contributer

You need to start by getting the main jets right and I would say you need to go up on them. Optimal jetting goes mains needles and then pilots. Those needles shouldn't have much to do at such low throttle opening. Were the pilot jets changed?

Link to comment
Share on other sites

I concur in my 1986 VFR750F ram air though I am running 132 or 134 main jets 34mm Keihm.  VF1000R are 36mm so 130-135 . Which jets are you running? It sound like something is clogged or sticking  Did you install the spring and diaphragm correctly?  Torn diaphragm or incorrectly installed.  They need to be sealed correctly in the groove ie vacuum nipple. Clogged main jet float doubtful.  Check diaphragm the needle should go down quickly  in the bore when you push them up individually should be about the same for all 4.  When you installed needle are they locked in place ie clockwise  did you have to enlarge holes at the diaphragm? There are tiny little holes in the sides of the pilot jets check those.  Float be be smooth going up and down you can measure the height pain in the ass with a float height setting tool  not necessary if they go up and down. Check float valve needle most important if the top does not retract internally it is defective it control float opening and closing correctly and adding enough fuel.  DONOT BEAT ON THE BIKE IT IS RUNNING TOO LEAN.

 

s-l1600.jpg TINY HOLES PILOT JET

 

image.thumb.jpeg.dd9fe14f49e02684c8c7d20776c867d8.jpeg

Link to comment
Share on other sites

Got the bike rejetted today and finally made the 100hp club, just! 

 

C5ECCFDE-B184-4DC7-B08F-9C74362FEC3F.thumb.jpeg.f1380d9d1ab1f2afdc6f3bf7436f32c6.jpeg

 

Dynojet main jets changed from 122 up to 136, needles moved two places and then some fine tuning of fuel enrichment = 101hp at the wheels. 

totally transformed the bike and enjoyed every second of the 60 mile ride home! 
 

1035375F-6811-4151-83BC-EAB627F7A62E.thumb.jpeg.66fa1944c96171f3f7b860331853a6cb.jpeg


4A8DCFE6-B6E7-4AFF-98E0-676F24454F0F.thumb.jpeg.0910de2d941844e16b98a639598e3489.jpeg

Link to comment
Share on other sites

  • Member Contributer

Very cool.  The pull of the liter V4 is nice.  I think I have 135s in my 85 with a Full Sudco 4-1.  My 86 with the same Kerker slip-ons, K&N, snorkels intact, pretty sure I have 130s.  Both bikes shimmed stock needles and 40 pilots.

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...

Important Information

By using this site, you agree to our Privacy Policy.