Member Contributer Skids Posted April 16, 2022 Member Contributer Share Posted April 16, 2022 Another issue I'm struggling to answer is the tightening of the rear PCV bleed valve located beneath the seat, alongside the rear tank mount. I've replaced the brake hose into the PCV and need to tighten it but it's so far below the bleed valve that I can't get a socket on it and therfore cannot connect my torque wrench so how do you torque it? Do I need another tool for this job? Also, what the correct torque? I'm thinking 34Nm. Thanks in advance. Link to comment Share on other sites More sharing options...
Member Contributer bmart Posted April 17, 2022 Member Contributer Share Posted April 17, 2022 Torque it? Just make it snug like any other brake bleed nipple. Link to comment Share on other sites More sharing options...
Member Contributer Terry Posted April 17, 2022 Member Contributer Share Posted April 17, 2022 Yeah, what Bmart says, it just needs to be snugged up so it doesn't weep. 34N-m is huge, only for the 10mm thread brake hose joint bolts at the callipers...don't do it! The service manual says 6 N-m for bleed nipples, which is bugger-all. Link to comment Share on other sites More sharing options...
Member Contributer Skids Posted April 17, 2022 Author Member Contributer Share Posted April 17, 2022 3 hours ago, Terry said: Yeah, what Bmart says, it just needs to be snugged up so it doesn't weep. 34N-m is huge, only for the 10mm thread brake hose joint bolts at the callipers...don't do it! The service manual says 6 N-m for bleed nipples, which is bugger-all. 6Nm is fine for bleed nipples alone which I do usually do by hand, but the PCV bleed nipple has a brake hose joint below it so it has to be tightened the same as the ones on the callipers. Take a look at the photo I attached above, below the bleed nipple is brake hose and it's so far below the bleed nipple that I can't get a socket over it. I guess I could remove the bleed nipple, hadn't thought of that. I'll give it a try. Link to comment Share on other sites More sharing options...
Member Contributer Terry Posted April 17, 2022 Member Contributer Share Posted April 17, 2022 Just goes to show that I don't read posts carefully before commenting. I agree that you need the higher torque for the oil hose bolt below the nipple. Link to comment Share on other sites More sharing options...
Member Contributer Skids Posted April 17, 2022 Author Member Contributer Share Posted April 17, 2022 It worked, nipple removed allows socket onto banjo bolt. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.