VietHorse

And this is RIGHT thread which I wanted to SEE and FOLLOW. Thank you, guys.

My super easy GPS mount:

I got the same thing installed on my VFR. As you can see in the link and photo below. As I am not the electric expert, I was having concern that this one would continuously converting power from 12VDC to 5VDC if you having no kill switch. That why I was making sure the battery safe from that concern, there was an On-Off switch installed between the battery and the USB port. Correct me if I am wrong. Thanks. Link to the thread: Click. Installation location photo:

Awesome! It's really high tech. How much does it cost for this mod?

Oops... Never seen such recommendation. Actually I asked for a K&N or a BMC but I got the BikeMaster one. However, I was thinking of that 's not a bad one in comparison with the OEM air filter. Yes, I did remove the gasket at the first place. But the problem still.

I have just replaced the OEM air filter by BikeMaster filter. Removing the OEM without any issue, but when install the Bike Master filter, I found difficult to get the edge of the filter to be fit/aligned with the cover and the filter housing. I did expect some kind of "click" sound when three parts fit together, but the rubber part of the filter seems too soft, it kept misaligned. The filter part which toward the rear is a bit easier to adjust, but the part toward the front, there is no room, no gap from the filter to the frame, so I could not adjust. Any idea, pls.

Thanks FrankoQ. I have installed LeoVince exhausts and just realized that need to have an aftermarket air-filter.

Someone must be a fashion designer:

Love it but it won't work here. Need another windshield for the cam.

My previous VFR 6th Gen also has the steering bar. However, I think the tripple clamp has been replaced by the Jap Police version and it has the OEM clamps and others.

I am a member of travel forum in Vietnam, we usually have banner/stickers for each of our tour to stick on cars as you can see in the below photos. After tour, we do our cleaning job, including removal of all stickers/banners. Just simply use hands to peel off the stickers. Apply diesel (fuel) oil to the remaining glue by a soft cloth. Wait for about 30-60secs, use dry cloth to clean, tenderly. All gone. The paint surface now clean and shines.

Thanks MaxSwell and others to pull this thread up. I may need time to read this carefully...