blackbird1137 Posted October 1, 2017 Share Posted October 1, 2017 Bike was recalled to replace the drive shaft ever since the vibration through the seat & handle bars has been very high & gives me pins & needles any idea how to get rid of it bike shop had it back twice their technician also agreed he gets pins & needles when he rode it Link to comment Share on other sites More sharing options...
Member Contributer GatorGreg Posted October 1, 2017 Member Contributer Share Posted October 1, 2017 Very sorry to hear that - I would just trade it in for an 8th gen (this is the 8th gen sub-forum ) Link to comment Share on other sites More sharing options...
Member Contributer Thumbs Posted October 2, 2017 Member Contributer Share Posted October 2, 2017 If you can feel the vibration with the bike in neutral then it's the engine if you can only feel it on the move it'll be in the transmission in which case I'd guess at the drive shaft housing alignment not being correct, put it on the centre stand and see if it looks straight on top of the shaft housing, same for the side Unless it's perfectly straight you need to slacken the housing bolts then do them back up slowly and symmetrically, I'd guess some body did the bolts up by going around them instead of diagonally Link to comment Share on other sites More sharing options...
Member Contributer fink Posted October 2, 2017 Member Contributer Share Posted October 2, 2017 Take it back to the dealers and get them to sort it. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.