Member Contributer rhoderage Posted June 19, 2017 Member Contributer Share Posted June 19, 2017 As I am preparing to install my Seb's clear clutch cover, I noticed after I removed the pressure plate that the clutch springs have been rubbing on their 'posts' enough that there are grooves worn into the metal, maybe 1mm deep or so (shallow but noticeable) Is this normal? What would cause this? Any need to replace the clutch basket? Upon measuring the clutch springs themselves, 2 are below the service limit (in the range of 45.3 mm), while 3 are at the service limit (45.8 mm), so I will be replacing the set. Link to comment Share on other sites More sharing options...
Member Contributer VFROZ Posted June 19, 2017 Member Contributer Share Posted June 19, 2017 The basket will be fine. You can install Barnetts + 10% springs for a bit more stiffness. Just make sure you inspect the bolts, they tend to strech and then break when you try to reinstall them. Link to comment Share on other sites More sharing options...
Member Contributer rhoderage Posted June 19, 2017 Author Member Contributer Share Posted June 19, 2017 Guessing its not 3am in Australia? Thanks for the quick reply! So if the bolts are stretched beyond the 25mm stock measurement they should hit the bin? Appreciate it! Link to comment Share on other sites More sharing options...
nicholas042416 Posted June 19, 2017 Share Posted June 19, 2017 For the cost mine as well just replace the bolts and springs....cheap insurance. Sent from my iPhone using Tapatalk Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.