Guest Gatordrummer88 Posted April 10, 2013 Share Posted April 10, 2013 I tried to put my 06 interceptor into gear but when I did and let the clutch out it didn't budge. I put it in gear and used no gas and let the clutch out to see if it would kill the bike but it didn't it acted like the bike was still in neutral. Link to comment Share on other sites More sharing options...
Member Contributer gmtech94 Posted April 10, 2013 Member Contributer Share Posted April 10, 2013 How long has the bike been sitting the clutch plates will lock up with oil holding them together if it has sat for a long time ,put the bike in 2nd gear engine off and rock it back and forth with the clutch pulled in this will likely free up the clutch plates enough to operate properly . Good luck! Link to comment Share on other sites More sharing options...
Guest Posted April 10, 2013 Share Posted April 10, 2013 When the resovioure is cooled down it started working again like it is supposed to. Thanks for the advice. What do you think I should do for that? Link to comment Share on other sites More sharing options...
Member Contributer hondalover Posted April 10, 2013 Member Contributer Share Posted April 10, 2013 Bleed/flush the fluid from the system. Link to comment Share on other sites More sharing options...
Guest Posted April 10, 2013 Share Posted April 10, 2013 Ok I will try that thank you. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.